1 #******************************************************************************
\r
3 # Copyright (c) 2019 Intel.
\r
5 # Licensed under the Apache License, Version 2.0 (the "License");
\r
6 # you may not use this file except in compliance with the License.
\r
7 # You may obtain a copy of the License at
\r
9 # http://www.apache.org/licenses/LICENSE-2.0
\r
11 # Unless required by applicable law or agreed to in writing, software
\r
12 # distributed under the License is distributed on an "AS IS" BASIS,
\r
13 # WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
\r
14 # See the License for the specific language governing permissions and
\r
15 # limitations under the License.
\r
17 #******************************************************************************/
\r
20 # This is simple configuration file. Use '#' sign for comments
\r
21 instanceId=1 # 0,1,2,... in case more than 1 application started on the same system
\r
22 appMode=1 # O-DU(0) | O-RU(1)
\r
23 xranMode=0 # Category A (0) (precoder in lls-CU) | Category B (1) (precoder in RU)
\r
24 ccNum=1 # Number of Componnent Carriers (CC) per ETH port with XRAN protocol (default:1 max: 12)
\r
25 antNum=4 # Number of Antennas per CC (default: 4) or number of Digital streams for Category B
\r
28 mu=0 #15Khz Sub Carrier Spacing
\r
29 ttiPeriod=1000 # in us TTI period (15Khz default 1000us)
\r
30 nDLAbsFrePointA=2645460 #nAbsFrePointA - Abs Freq Point A of the Carrier Center Frequency for in KHz Value: 450000->52600000
\r
31 nULAbsFrePointA=2525460 #nAbsFrePointA - Abs Freq Point A of the Carrier Center Frequency for in KHz Value: 450000->52600000
\r
32 nDLBandwidth=20 #Carrier bandwidth for in MHz. Value: 5->400
\r
33 nULBandwidth=20 #Carrier bandwidth for in MHz. Value: 5->400
\r
37 nFrameDuplexType=0 # 0 - FDD 1 - TDD
\r
38 nTddPeriod=0 #TDD priod e.g. DDDS 4
\r
40 MTUSize=9600 #maximum transmission unit (MTU) is the size of the largest protocol data unit (PDU) that can be communicated in a single
\r
41 #xRAN network layer transaction. supported 1500 bytes and 9600 bytes (Jumbo Frame)
\r
42 Gps_Alpha=0 #alpha and beta value as in section 9.7.2 of ORAN spec
\r
50 llsCUMac=00:11:22:33:44:66 # asigned MAC of lls-CU VF
\r
51 #llsCUMac=3c:fd:fe:a8:e0:70
\r
52 ruMac=00:11:22:33:44:55 #RU VF for RU app
\r
53 numSlots=40 #number of slots per IQ files
\r
54 antC0=./usecase/mu0_20mhz/ant_0.bin #CC0
\r
55 antC1=./usecase/mu0_20mhz/ant_1.bin #CC0
\r
56 antC2=./usecase/mu0_20mhz/ant_2.bin #CC0
\r
57 antC3=./usecase/mu0_20mhz/ant_3.bin #CC0
\r
58 antC4=./usecase/mu0_20mhz/ant_4.bin #CC1
\r
59 antC5=./usecase/mu0_20mhz/ant_5.bin #CC1
\r
60 antC6=./usecase/mu0_20mhz/ant_6.bin #CC1
\r
61 antC7=./usecase/mu0_20mhz/ant_7.bin #CC1
\r
62 antC8=./usecase/mu0_20mhz/ant_8.bin #CC2
\r
63 antC9=./usecase/mu0_20mhz/ant_9.bin #CC2
\r
64 antC10=./usecase/mu0_20mhz/ant_10.bin #CC2
\r
65 antC11=./usecase/mu0_20mhz/ant_11.bin #CC2
\r
66 antC12=./usecase/mu0_20mhz/ant_12.bin #CC3
\r
67 antC13=./usecase/mu0_20mhz/ant_13.bin #CC3
\r
68 antC14=./usecase/mu0_20mhz/ant_14.bin #CC3
\r
69 antC15=./usecase/mu0_20mhz/ant_15.bin #CC3
\r
71 ## RACH TODO: update for PRACH
\r
72 rachEanble=1 # Enable (1)| disable (0) PRACH configuration
\r
73 #rachOffset=43 # RB offset for prach detection (see RIU spec)
\r
74 prachConfigIndex=189 # PRACH config index as per TS36.211 - Table 5.7.1-2 : PRACH Configuration Index
\r
76 antPrachC0=./usecase/mu0_20mhz/ant_0.bin
\r
77 antPrachC1=./usecase/mu0_20mhz/ant_1.bin
\r
78 antPrachC2=./usecase/mu0_20mhz/ant_2.bin
\r
79 antPrachC3=./usecase/mu0_20mhz/ant_3.bin
\r
82 ## control of IQ byte order
\r
83 iqswap=0 #do swap of IQ before send buffer to eth
\r
84 nebyteorderswap=1 #do swap of byte order for each I and Q from CPU byte order to network byte order
\r
87 debugStop=1 #stop app on 1pps boundary (gps_second % 30)
\r
88 debugStopCount=0 #if this value is >0 then stop app after x transmission packets, otherwise app will stop at 1pps boundary
\r
89 bbdevMode=-1 #bbdev mode, -1 = not use bbdev, 0: use software mode, 1: use hardware mode
\r
91 CPenable=1 #(1) C-Plane is enabled| (0) C-Plane is disabled
\r
92 c_plane_vlan_tag=1 #VLAN Tag used for C-Plane
\r
93 u_plane_vlan_tag=2 #VLAN Tag used for U-Plane
\r
96 totalBFWeights=32 # Total number of Beamforming Weights on RU
\r
98 Tadv_cp_dl=25 #in us TODO: update per RU implementation
\r
99 #C-Plane messages must arrive at the RU some amount of time in advance (Tcp_adv_dl) of the corresponding U-Plane messages
\r
101 #Reception Window C-plane DL
\r
102 T2a_min_cp_dl=400 #in us
\r
103 T2a_max_cp_dl=1120 #in us
\r
105 #Reception Window C-plane UL
\r
106 T2a_min_cp_ul=400 #in us
\r
107 T2a_max_cp_ul=1120 #in us
\r
109 #Reception Window U-plane
\r
110 T2a_min_up=200 # in us
\r
111 T2a_max_up=1120 # in us
\r
113 #Transmission Window
\r
117 ###########################################################
\r
120 #Transmission Window Fast C-plane DL
\r
124 ##Transmission Window Fast C-plane UL
\r
129 ##Transmission Window
\r
136 ###########################################################
\r