-/******************************************************************************
-*
-* Copyright (c) 2019 Intel.
-*
-* Licensed under the Apache License, Version 2.0 (the "License");
-* you may not use this file except in compliance with the License.
-* You may obtain a copy of the License at
-*
-* http://www.apache.org/licenses/LICENSE-2.0
-*
-* Unless required by applicable law or agreed to in writing, software
-* distributed under the License is distributed on an "AS IS" BASIS,
-* WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
-* See the License for the specific language governing permissions and
-* limitations under the License.
-*
-*******************************************************************************/
-
-
-/**
- * @brief
- * @file
- * @ingroup
- * @author Intel Corporation
- **/
-
-#ifndef _SAMPLEAPP__CONFIG_H_
-#define _SAMPLEAPP__CONFIG_H_
-
-#include <stdint.h>
-#include <rte_ether.h>
-#include "xran_fh_o_du.h"
-
-/** Run time configuration of application */
-typedef struct _RuntimeConfig
-{
- uint8_t appMode; /**< Application mode: lls-CU or RU */
- uint8_t xranMode; /**< xran mode: Categoty A | Category B */
- uint8_t numCC; /**< Number of CC per ports supported by RU */
- uint8_t numAxc; /**< Number of Antenna Carriers per CC */
- uint32_t ttiPeriod; /**< TTI period */
- uint32_t testVect; /**< Test Signal to send */
- struct ether_addr o_du_addr; /**< lls-CU Ethernet Mac Address */
- struct ether_addr o_ru_addr; /**< RU Ethernet Mac Address */
- struct ether_addr tmp_addr; /**< Temp Ethernet Mac Address */
-
- uint32_t mtu; /**< maximum transmission unit (MTU) is the size of the largest protocol data unit (PDU) that can be communicated in a single
- xRAN network layer transaction. supported 1500 bytes and 9600 bytes (Jumbo Frame) */
- int numSlots; /**< number of slots in IQ vector */
- char ant_file[XRAN_MAX_SECTOR_NR*XRAN_MAX_ANTENNA_NR][512] /**< file to use for test vector */ ;
- char prach_file[XRAN_MAX_SECTOR_NR*XRAN_MAX_ANTENNA_NR][512] /**< file to use for test vector */ ;
-
- /* prach config */
- uint8_t enablePrach; /**< enable PRACH */
- uint8_t prachOffset; /**< Sets the PRACH position in frequency / subcarrier position, n_PRBoffset^RA and is expressed as a physical resource block number.
- Set by SIB2, prach-FreqOffset in E-UTRA. */
-
- uint8_t prachConfigIndex; /**< TS36.211 - Table 5.7.1-2 : PRACH Configuration Index */
- uint8_t iqswap; /**< do swap of IQ before send to ETH */
- uint8_t nebyteorderswap; /**< do swap of byte order from host byte order to network byte order. ETH */
-
- uint16_t Tadv_cp_dl;
- uint16_t T2a_min_cp_dl;
- uint16_t T2a_max_cp_dl;
- uint16_t T2a_min_cp_ul;
- uint16_t T2a_max_cp_ul;
- uint16_t T2a_min_up;
- uint16_t T2a_max_up;
- uint16_t Ta3_min;
- uint16_t Ta3_max;
- uint16_t T1a_min_cp_dl;
- uint16_t T1a_max_cp_dl;
- uint16_t T1a_min_cp_ul;
- uint16_t T1a_max_cp_ul;
- uint16_t T1a_min_up;
- uint16_t T1a_max_up;
- uint16_t Ta4_min;
- uint16_t Ta4_max;
-
- uint8_t enableCP; /**< enable C-plane */
- uint8_t cp_vlan_tag; /**< C-plane vlan tag */
- uint8_t up_vlan_tag; /**< U-plane vlan tag */
-
- int32_t debugStop;
- int32_t debugStopCount;
- int32_t bbdevMode;
- int32_t DynamicSectionEna;
-
- uint8_t mu_number; /**< Mu numner as per 3GPP */
- uint32_t nDLAbsFrePointA; /**< Abs Freq Point A of the Carrier Center Frequency for in KHz Value: 450000->52600000 */
- uint32_t nULAbsFrePointA; /**< Abs Freq Point A of the Carrier Center Frequency for in KHz Value: 450000->52600000 */
- uint32_t nDLBandwidth; /**< Carrier bandwidth for in MHz. Value: 5->400 */
- uint32_t nULBandwidth; /**< Carrier bandwidth for in MHz. Value: 5->400 */
- uint32_t nDLFftSize; /**< DL FFT size */
- uint32_t nULFftSize; /**< UL FFT size */
-
-
- uint8_t nFrameDuplexType;
- uint8_t nTddPeriod;
- struct xran_slot_config sSlotConfig[XRAN_MAX_TDD_PERIODICITY];
-} RuntimeConfig;
-
-/**
- * Parse application configuration file.
- *
- * @param filename The name of the configuration file to be parsed.
- * @param config The configuration structure to be filled with parsed data. */
-int parseConfigFile(char *filename, RuntimeConfig *config);
-
-#endif /* _SAMPLEAPP__CONFIG_H_ */
+/******************************************************************************\r
+*\r
+* Copyright (c) 2019 Intel.\r
+*\r
+* Licensed under the Apache License, Version 2.0 (the "License");\r
+* you may not use this file except in compliance with the License.\r
+* You may obtain a copy of the License at\r
+*\r
+* http://www.apache.org/licenses/LICENSE-2.0\r
+*\r
+* Unless required by applicable law or agreed to in writing, software\r
+* distributed under the License is distributed on an "AS IS" BASIS,\r
+* WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.\r
+* See the License for the specific language governing permissions and\r
+* limitations under the License.\r
+*\r
+*******************************************************************************/\r
+\r
+/**\r
+ * @brief\r
+ * @file\r
+ * @ingroup\r
+ * @author Intel Corporation\r
+ **/\r
+\r
+#ifndef _SAMPLEAPP__CONFIG_H_\r
+#define _SAMPLEAPP__CONFIG_H_\r
+\r
+#include <stdint.h>\r
+#include <rte_ether.h>\r
+#include "xran_fh_o_du.h"\r
+\r
+/** Run time configuration of application */\r
+typedef struct _RuntimeConfig\r
+{\r
+ uint8_t appMode; /**< Application mode: lls-CU or RU */\r
+ uint8_t xranCat; /**< xran mode: Categoty A | Category B */\r
+ uint8_t numCC; /**< Number of CC per ports supported by RU */\r
+ uint8_t numAxc; /**< Number of Antenna Carriers per CC */\r
+ uint8_t numUlAxc; /**< Number of Antenna Carriers per CC for UL (Cat B) */\r
+ uint32_t antElmTRx; /**< Number of antenna elements for TX and RX */\r
+ uint32_t muMimoUEs; /**< Number of UEs (with 1 RX ant)/beams */\r
+\r
+ uint32_t DlLayersPerUe; /**< Number of DL layer per UE */\r
+ uint32_t UlLayersPerUe; /**< Number of UL layer per UE */\r
+\r
+ uint32_t ttiPeriod; /**< TTI period */\r
+ uint32_t testVect; /**< Test Signal to send */\r
+ struct ether_addr o_du_addr; /**< lls-CU Ethernet Mac Address */\r
+ struct ether_addr o_ru_addr; /**< RU Ethernet Mac Address */\r
+ struct ether_addr tmp_addr; /**< Temp Ethernet Mac Address */\r
+\r
+ uint32_t instance_id; /**< Instance ID of application */\r
+ uint32_t io_core; /**< Core used for IO */\r
+\r
+ uint32_t mtu; /**< maximum transmission unit (MTU) is the size of the largest protocol data unit (PDU) that can be communicated in a single\r
+ xRAN network layer transaction. supported 1500 bytes and 9600 bytes (Jumbo Frame) */\r
+ int numSlots; /**< number of slots in IQ vector */\r
+ char ant_file[XRAN_MAX_SECTOR_NR*XRAN_MAX_ANTENNA_NR][512]; /**< file to use for test vector */\r
+ char prach_file[XRAN_MAX_SECTOR_NR*XRAN_MAX_ANTENNA_NR][512]; /**< file to use for test vector */\r
+\r
+ char dl_bfw_file [XRAN_MAX_SECTOR_NR*XRAN_MAX_ANTENNA_NR][512]; /**< file with beamforming weights for DL streams */\r
+ char ul_bfw_file [XRAN_MAX_SECTOR_NR*XRAN_MAX_ANTENNA_NR][512]; /**< file with beamforming weights for UL streams */\r
+\r
+ char ul_srs_file [XRAN_MAX_SECTOR_NR*XRAN_MAX_ANT_ARRAY_ELM_NR][512]; /**< file with SRS content for UL antenna elements */\r
+\r
+ /* prach config */\r
+ uint8_t enablePrach; /**< enable PRACH */\r
+ uint8_t prachOffset; /**< Sets the PRACH position in frequency / subcarrier position, n_PRBoffset^RA and is expressed as a physical resource block number.\r
+ Set by SIB2, prach-FreqOffset in E-UTRA. */\r
+\r
+ uint8_t prachConfigIndex; /**< TS36.211 - Table 5.7.1-2 : PRACH Configuration Index */\r
+ uint8_t iqswap; /**< do swap of IQ before send to ETH */\r
+ uint8_t nebyteorderswap; /**< do swap of byte order from host byte order to network byte order. ETH */\r
+ uint8_t compression; /**< enable use case with compression */\r
+\r
+ uint16_t totalBfWeights; /**< The total number of beamforming weights on RU */\r
+\r
+ uint8_t enableSrs; /**< enable SRS (valid for Cat B only) */\r
+ uint16_t srsSymMask; /**< SRS symbol mask [014] within S/U slot [0-13] def is 13 */\r
+\r
+ uint16_t maxFrameId; /**< max value of frame id */\r
+\r
+ uint16_t Tadv_cp_dl;\r
+ uint16_t T2a_min_cp_dl;\r
+ uint16_t T2a_max_cp_dl;\r
+ uint16_t T2a_min_cp_ul;\r
+ uint16_t T2a_max_cp_ul;\r
+ uint16_t T2a_min_up;\r
+ uint16_t T2a_max_up;\r
+ uint16_t Ta3_min;\r
+ uint16_t Ta3_max;\r
+ uint16_t T1a_min_cp_dl;\r
+ uint16_t T1a_max_cp_dl;\r
+ uint16_t T1a_min_cp_ul;\r
+ uint16_t T1a_max_cp_ul;\r
+ uint16_t T1a_min_up;\r
+ uint16_t T1a_max_up;\r
+ uint16_t Ta4_min;\r
+ uint16_t Ta4_max;\r
+\r
+ uint8_t enableCP; /**< enable C-plane */\r
+ uint8_t cp_vlan_tag; /**< C-plane vlan tag */\r
+ uint8_t up_vlan_tag; /**< U-plane vlan tag */\r
+\r
+ int32_t debugStop;\r
+ int32_t debugStopCount;\r
+ int32_t bbdevMode;\r
+ int32_t DynamicSectionEna;\r
+ int32_t GPS_Alpha;\r
+ int32_t GPS_Beta;\r
+\r
+ uint8_t mu_number; /**< Mu numner as per 3GPP */\r
+ uint32_t nDLAbsFrePointA; /**< Abs Freq Point A of the Carrier Center Frequency for in KHz Value: 450000->52600000 */\r
+ uint32_t nULAbsFrePointA; /**< Abs Freq Point A of the Carrier Center Frequency for in KHz Value: 450000->52600000 */\r
+ uint32_t nDLBandwidth; /**< Carrier bandwidth for in MHz. Value: 5->400 */\r
+ uint32_t nULBandwidth; /**< Carrier bandwidth for in MHz. Value: 5->400 */\r
+ uint32_t nDLFftSize; /**< DL FFT size */\r
+ uint32_t nULFftSize; /**< UL FFT size */\r
+\r
+\r
+ uint8_t nFrameDuplexType;\r
+ uint8_t nTddPeriod;\r
+ struct xran_slot_config sSlotConfig[XRAN_MAX_TDD_PERIODICITY];\r
+ struct xran_prb_map PrbMapDl;\r
+ struct xran_prb_map PrbMapUl;\r
+} RuntimeConfig;\r
+\r
+/**\r
+ * Parse application configuration file.\r
+ *\r
+ * @param filename The name of the configuration file to be parsed.\r
+ * @param config The configuration structure to be filled with parsed data. */\r
+int parseConfigFile(char *filename, RuntimeConfig *config);\r
+\r
+#endif /* _SAMPLEAPP__CONFIG_H_ */\r
Code Review / o-du / phy.git / blobdiff