-The support for the eCPRI one- way delay measurements which are specified by
-the O-RAN to be used with the Measured Transport support per Section 2.3.3.3
-of the O-RAN-WG4.CUS.0-v4.00 specification and section 3.2.4.6 of the eCPRI_v2.0
-specification is implemented in the file xran_delay_measurement.c. Structure
-definitions used by the owd measurement functions are in the file xran_fh_o_du.h
-for common data and port specific variables and parameters.
-
-The implementation of this feature has been done under the assumption that the requestor
-is the O-DU and the recipient is the O-RU. All of the action_types per the eCPRI 2.0 have
-been implemented. In the current version the timestamps are obtained using the linux
-function clock_gettime using CLOCK_REALTIME as the clock_id argument.
-
-The implementation supports both the O-RU and the O-DU side in order to do the unit test
-in loopback mode.
-
-The one-delay measurements are enabled at configuration time and run right after the
-xran_start() function is executed. The total number of consecutive measurements per port
-should be a power of 2 and in order to minimize the system startup it is advisable that
-the number is 16 or below.
+The support for the eCPRI one- way delay measurements which are
+specified by the O-RAN to be used with the Measured Transport support
+per Section 2.3.3.3 of the O-RAN-WG4.CUS.0-v4.00 specification and
+section 3.2.4.6 of the eCPRI_v2.0 specification is implemented in the
+file xran_delay_measurement.c. Structure definitions used by the owd
+measurement functions are in the file xran_fh_o_du.h for common data and
+port specific variables and parameters.
+
+The implementation of this feature has been done under the assumption
+that the requestor is the O-DU and the recipient is the O-RU. All of the
+action_types per the eCPRI 2.0 have been implemented. In the current
+version the timestamps are obtained using the linux function
+clock_gettime using CLOCK_REALTIME as the clock_id argument.
+
+The implementation supports both the O-RU and the O-DU side in order to
+do the unit test in loopback mode.
+
+The one-delay measurements are enabled at configuration time and run
+right after the xran_start() function is executed. The total number of
+consecutive measurements per port should be a power of 2 and in order to
+minimize the system startup it is advisable that the number is 16 or
+below.