echo " -c allows user to set the target coverage for a module to pass; default is 80"
echo " -f forces a discount check (normally done only if coverage < target)"
echo " -F show only failures at the function level"
+ echo " -Q turns off quiet mode. Quiet mode (default) is less chatty about intermediate"
+ echo " coverage results and test programme output when failures detected"
+ echo " -q enable quiet mode (default, so this is no longer needed)"
echo " -s strict mode; code coverage must also pass to result in a good exit code"
echo " -v will write additional information to the tty and save the disccounted file if discount run or -f given"
echo " -x generates the coverage XML files for Sonar (implies -f)"
show_all=1 # show all things -F sets to show failures only
strict=0 # -s (strict) will set; when off, coverage state ignored in final pass/fail
show_output=0 # show output from each test execution (-S)
-quiet=0
+quiet=1 # less chatty with result output (only overall coverage, no intermediate coverage) -Q turns off
gen_xml=0
replace_flags=1 # replace ##### in gcov for discounted lines
run_nano_tests=0 # can nolonger be turned on
-S) show_output=1;; # test output shown even on success
-v) (( verbose++ ));;
-q) quiet=1;; # less chatty when spilling error log files
+ -Q) quiet=0;; # disable quiet mode
-x) gen_xml=1
force_discounting=1
trigger_discount_str="WARN|FAIL|PASS" # check all outcomes for each module
continue
fi
- echo "<INFO> add test: $tfile" >&2
+ if (( ! quiet ))
+ then
+ echo "<INFO> add test: $tfile" >&2
+ fi
flist="${flist}$tfile "
fi
done
flist="$@"
fi
-
if (( noexec ))
then
echo "no exec mode; would test these:"
printf "\n============= test programme output =======================\n"
cat /tmp/PID$$.log
printf "===========================================================\n"
+ else
+ grep "SUMMARY" /tmp/PID$$.log
fi
fi
if (( rc || force_discounting )) # didn't pass, or forcing, see if discounting helps
then
- if (( ! verbose ))
+ if (( ! verbose )) # if verbose is on we don't need this (! is not a mistake!!)
then
echo "[INFO] checking to see if discounting improves coverage for failures listed above"
fi
if (( ! quiet ))
then
cat /tmp/PID$$.noise
+ else
+ grep "SUMMARY" /tmp/PID$$.noise
fi
done
fi
fi
+# finally run any "vetters" which run programmes and analyse the output
+echo "[INFO] running vetters...."
+if ! make vet
+then
+ echo "[FAIL] one or more vetters failed"
+ state=1
+else
+ echo "[INFO] vetters all passed"
+fi
+
echo""
if (( state ))
then