b. ifconfig <interface name>:CU_STUB "192.168.130.82"
c. ifconfig <interface name>:RIC_STUB "192.168.130.80"
+PS: If O1 interface is enabled, IPs should match those configured in "startup_config.xml"
+ ( Refer Installation Guide - "Setting up Netconf server" )
+
2. Execute CU Stub:
a. Navigate to CU execution folder
- ./odu
-PS: CU stub and RIC stub must be run (in no particular sequence) before ODU
+PS: CU stub and RIC stub must be run (in no particular sequence) before ODU.
II. Execution - Using Docker Images
^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^
.. figure:: O-DU_High_Low_Flow.jpg
:width: 600
- :alt: Figure 1 O-DU High - O-DU Low Message Flow Diagram
+ :alt: Figure 7 O-DU High - O-DU Low Message Flow Diagram
- Figure 5 - O-DU High - O-DU Low Message Flow Diagram
+ Figure 7 - O-DU High - O-DU Low Message Flow Diagram
Note: UL IQ-Sample request and response are needed by Intel O-DU Low in timer mode(testing mode) only. Code changes for
these are guarded under INTEL_TIMER_MODE flag which can be enabled using compilation option "PHY_MODE=TIMER", as
mentioned in section B.I.1.d .
+
+
+D. Health Check execution: get alarm-list
+-------------------------------------------
+
+To execute the get alarm-list flow, following steps are required to be executed:
+
+ 1. Start Netconf netopeer client
+
+ 2. Connect to the server with
+
+ | user: netconf
+ | pwd: netconf!
+
+ 3. Send a Netconf get request for alarms xpath
+
+Here are the steps as executed in the terminal
+
+ | netopeer2-cli
+ | > connect --login netconf
+ | Interactive SSH Authentication
+ | Type your password:
+ | Password:
+ | > get --filter-xpath /o-ran-sc-odu-alarm-v1\:odu/alarms
+ | DATA
+ | <odu xmlns=\"urn\:o-ran\:odu\:alarm\:1.0\">
+ | <alarms>
+ | <alarm>
+ | <alarm-id>1009</alarm-id>
+ | <alarm-text>cell id [1] is up</alarm-text>
+ | <severity>2</severity>
+ | <status>Active</status>
+ | <additional-info>cell UP</additional-info>
+ | </alarm>
+ | </alarms>
+ | </odu>
+
+The XML output is a list of active alarms in the O-DU High system.
+
+Note: Integration with SMO/OAM is not yet done so a Netconf CLI client(netopeer2-cli) is used to connect to the Netconf server and send the get request.