User Guide
***********
-This is the user guide for Cherry release of O-DU/l2.
+This is the user guide for D release of O-DU/l2.
Follow installation-guide to get all the dependencies ready.
.. contents::
d. Build ODU Binary:
- - make odu PHY=INTEL_L1 PHY_MODE=TIMER MACHINE=BIT64 MODE=FDD
+ - make odu PHY=INTEL_L1 MACHINE=BIT64 MODE=FDD
III. Execution
b. Run O-DU Low binary :
- cd <O-DU Low Directory>/FlexRAN/l1/bin/nr5g/gnb/l1
- - To run in timer mode : ./l1.sh -e
+ - To run in radio mode : ./l1.sh -xran
- L1 is up when following prints are seen on console:
| Non BBU threads in application
O-DU High opens WLS interface during bring up. Message exchanges can begin once the interface is ready.
Following diagram shows P5 messages exchanged with O-DU Low in timer mode.
-.. figure:: O-DU_High_Low_Flow.jpg
+.. figure:: O-DU_High_Low_Flow.PNG
:width: 600
:alt: Figure 7 O-DU High - O-DU Low Message Flow Diagram
| </odu>
The XML output is a list of active alarms in the O-DU High system.
-
-Note: Integration with SMO/OAM is not yet done so a Netconf CLI client(netopeer2-cli) is used to connect to the Netconf server and send the get request.