+ This provides the interface that RMR will bind listen ports
+ to, allowing for a single interface to be used rather than
+ listening across all interfaces. This should be the IP
+ address assigned to the interface that RMR should listen on,
+ and if not defined RMR will listen on all interfaces.
+
+ * - **RMR_CTL_PORT**
+ -
+ This variable defines the port that RMR should open for
+ communications with Route Manager, and other RMR control
+ applications. If not defined, the port 4561 is assumed.
+
+ Previously, the ``RMR_RTG_SVC`` (route table generator
+ service port) was used to define this port. However, a future
+ version of Route Manager will require RMR to connect and
+ request tables, thus that variable is now used to supply the
+ Route Manager's well-known address and port.
+
+ To maintain backwards compatibility with the older Route
+ Manager versions, the presence of this variable in the
+ environment will shift RMR's behaviour with respect to the
+ default value used when ``RMR_RTG_SVC`` is **not** defined.
+
+ When ``RMR_CTL_PORT`` is **defined:** RMR assumes that Route
+ Manager requires RMR to connect and request table updates is
+ made, and the default well-known address for Route manager is
+ used (routemgr:4561).
+
+ When ``RMR_CTL_PORT`` is **undefined:** RMR assumes that
+ Route Manager will connect and push table updates, thus the
+ default listen port (4561) is used.
+
+ To avoid any possible misinterpretation and/or incorrect
+ assumptions on the part of RMR, it is recommended that both
+ the ``RMR_CTL_PORT`` and ``RMR_RTG_SVC`` be defined. In the
+ case where both variables are defined, RMR will behave
+ exactly as is communicated with the variable's values.
+
+ * - **RMR_RTREQ_FREQ**
+ -
+ When RMR needs a new route table it will send a request once
+ every ``n`` seconds. The default value for ``n`` is 5, but
+ can be changed if this variable is set prior to invoking the
+ process. Accepted values are between 1 and 300 inclusive.